Butt welding, rolling, flange welding and PFA high-purity piping — nine models covering 5–50 mm sheet and up to 6000 mm welding length. No rod, no chamfering: the seam is formed by the panel itself.
01Four standard sizes, 25 mm sheet, 1.5–4 m welding length.
View →
0250 mm sheet, 6 m length, independent control console.
View →
030.3–0.5 t, 4-inch screen, 15 mm sheet, fits against a wall.
View →
040.2 t, fully manual, runs without an air supply.
View →
05Automatic welding and rolling, one operator.
View →
06Eight welding stations, 70 mm flange edge.
View →
07Vertical clamping, up-and-down press instead of overhead welding.
View →
08High-purity fluoropolymer piping, four repeatable motions.
View →
093 m table, one-piece heated blade, 32 cylinders in balance.
View →Hand welding plastic sheet fails on control, not skill: temperature and pressure depend on feel, cold welds only show up in a water test, and two panels pulled together by hand end up tight on one side and loose on the other. A machine turns those into repeatable motions — heating time, temperature and pressing pressure are all set, and four-point balance keeps both sides at the same melt state.